How do I hook a reworked 5.3 harness into the ignition switch wiring?
Here is what the documentation says. Each point links to its source; details depend on your exact computer, harness and transmission.
- E38 ECM; Chevrolet Performance NA LS control kit 19171935; LS2/LS3/LS376/LS7/LSX454; 58x/4x; 2006+: Pink ignition-switch feed powers the E38 ECM ignition input. (Chevrolet Performance)
- 0411 PCM (GM service #9354896 or 12200411); 1999-2007 Vortec DBC (LM4/LM7/LQ4/LQ9/L33/L59); T56 or non-electronic automatic: Red ignition feed must be hot in ON and CRANKING. (PSI Conversion)
- 0411 PCM (GM service #9354896 or 12200411); 1999-2007 Vortec DBC (LM4/LM7/LQ4/LQ9/L33/L59); T56 or non-electronic automatic: No-start checks: ignition voltage in ON and crank, 58 psi fuel pressure. (PSI Conversion)
- E38/E67 ECM; Speartech 58x manual-transmission harness: Speartech pink 12-awg is switched 12 V in run and crank. (Speartech)
Confirm against the instructions for your exact parts before wiring. More: Harness and power in our tuning guide.
Confidence: medium — sources disagree or are limited; check the sources below.
Community discussion
Related questions
- Best LS swap wiring harness
- Stock PCM vs Holley Terminator X for an LS swap
- How do I tune an LS swap? (HP Tuners basics)
- How to make a standalone LS wiring harness
- VATS delete: what it is and how to do it
- Drive-by-wire vs cable throttle for an LS swap
Sources
- LS Series Engine Control System Guide — Chevrolet Performance (via Scribd)
- https://es.slideshare.net/slideshow/har-1019-vortec-swap-wiring-harness-instructions-efi-conversion-fro/47382494 — PSI Conversion
- https://speartech.com/v/vspfiles/instructions/58xman.pdf — Speartech