How do you wire a 5.3L truck harness into an E30 for a daily driver?
Here is what the documentation says. Each point links to its source; details depend on your exact computer, harness and transmission.
- E67 ECM; Chevrolet Performance LSA E-Rod control system 19299067; LSA: E38 connectors use slider-bar latches. (Chevrolet Performance)
- 0411 PCM (GM service #9354896 or 12200411); 1999-2007 Vortec DBC (LM4/LM7/LQ4/LQ9/L33/L59); T56 or non-electronic automatic: Unused wires are taped individually and secured. (PSI Conversion)
- Gen III PCM; Aeroflow AF49-1505; LS1/LS6; DBC; 4L60E/4L80E: Starter uses large black ring terminals; heat-sleeve wire under the manifold. (Aeroflow Performance)
- 0411/P59 factory harness strip-down: DIY harness stripping: depin unused circuits and plug empty cavities. (LSX Magazine)
Confirm against the instructions for your exact parts before wiring. More: Harness and power in our tuning guide.
Confidence: medium — sources disagree or are limited; check the sources below.
Community discussion
Related questions
- Best LS swap wiring harness
- Stock PCM vs Holley Terminator X for an LS swap
- How do I tune an LS swap? (HP Tuners basics)
- How to make a standalone LS wiring harness
- VATS delete: what it is and how to do it
- Drive-by-wire vs cable throttle for an LS swap
Sources
- https://es.slideshare.net/slideshow/har-1019-vortec-swap-wiring-harness-instructions-efi-conversion-fro/47382494 — PSI Conversion
- https://www.crateenginedepot.com/pdfs/lsa_e_rod.pdf — Chevrolet Performance
- https://aeroflowperformance.com/pub/media/Instructions_PDF/AF49-1505.pdf — Aeroflow Performance
- https://www.lsxmag.com/tech-stories/diy-or-buy-a-look-at-the-ls-standalone-harness-dilemma/ — LSX Magazine