Guide updates and tuning notes by email → Follow us

Home › Engines › LH8

LH8 5.3L engine: specs, donor vehicles & swap notes

The LH8 is a 5.3 L aluminum-block Generation IV engine built 2008–2009, rated 300 hp. It came in 2 vehicle applications, including Hummer H3 Alpha, Chevrolet Colorado/GMC Canyon.

We may earn a commission when you buy through links on this page.

SpecValue
RPOLH8
FamilyGeneration IV
Years2008–2009
Displacement5.3 L / 325 ci
Horsepower300 hp
Torque320 lb-ft
Bore × stroke3.78 × 3.622 in
Compression9.90:1
Blockaluminum
AFM/DODNo
VIN 8th digitL
Reluctor58x
Stock camCam PN 12625437; duration 191°/190° @.050 in. int./exh.; valve lift 0.457"/0.466" int./exh.; 114° LSA; 1-bolt gear, 4x; AFM No, VVT No.
Firing order1-8-7-2-6-5-4-3
Known issues:
  • Excessive oil consumption. Fix: Pro tip: Check oil level every 1,000 miles. Many 5.3 engines consume oil faster than expected.
  • Non-AFM lifter and camshaft wear. Fix: Change oil every 5,000 miles (instead of GM's longer intervals) with high-quality synthetic oil.
  • Knock sensor water intrusion. Fix: Check for water intrusion near knock sensors during intake manifold service.
  • Composite intake manifold cracking. Fix: Replace intake manifold and gasket; do not overtighten bolts.

Aluminum

The LH8 specs above are not yet confirmed against GM documents; GM ratings varied by year and vehicle.

How the LH8 differs from the other 5.3 L Gen IV engines

The LH8 is one of the eight 5.3 L Gen IV engines we list: LC9, LH6, LH8, LH9, LMF, LMG, LS4, LY5. From our engine table:

Swapping the LH8: what to plan for

Refresh parts for the LH8

From our Gen IV refresh list, the parts that are specific to the LH8. Seals, gaskets and the upgrades worth doing on any Gen IV with the engine out are in the full refresh list, next to every torque spec.

PartGM part #Why for this engine
LSXceleration Gen IV LS knock sensor 28-2373028-23730The LH8 has its knock sensors on the side of the block.
GM Gen IV camshaft position sensor 12591720 (58x engines)1259172058x LH8: the cam sensor lives in the front cover.
Chevrolet Performance 58x crankshaft position sensor 127036271270362758x LH8: the crank sensor is behind the starter.

What real 5.3 L Gen IV (E38) tunes run

What these settings look like in the 192 naturally aspirated pump-gas tunes for 5.3 L engines on an E38 computer in our tune library (as of 2026-10-15). These files do not record which 5.3 L it was (LC9, LMG, LY5 or another) or which vehicle, so this is the 5.3 L Gen IV (E38) naturally aspirated pool, not one RPO. Most files have no stock or aftermarket cam label, so stock and aftermarket stay in one table. The ranges are wide because every cam and build in that pool is included. Use them to spot a value that is far outside what works, not as your numbers.

SettingRangeMedianTunes
Hot idle target525 rpm to 800 rpm535 rpm192 (middle 80%)
Warm idle airflow, in gear6.0 g/s to 10.5 g/s6.8 g/s192 (middle 80%)
Idle spark (around 800 rpm)16° to 20°18°191 (middle 80%)
Power enrichment (PE) lambda0.76 to 0.850.78184 (middle 80%)
WOT spark at 5,000 rpm, about 0.9 g/cyl13.0° to 22.5°14.5°192 (middle 80%)

For starting values matched to your LH8's cam, injectors and fuel, use the turn-on tune builder. Always finish on a dyno, and read our safe tuning limits before any wide-open pass.

Donor vehicles with the LH8

Where to find an LH8 at the junkyard: 2 vehicle applications below. Confirm it from the RPO sticker in the glovebox or the 8th VIN digit (for the LH8: L).

VehicleYears
Chevrolet Colorado/GMC Canyon2009
Hummer H3 Alpha2008–2009

Buying a used LH8

A used LH8 has no single part number, so this page does not link a search. Confirm the engine from the RPO sticker or the 8th VIN digit (for the LH8: L) before you buy.

Next steps